Custom Bronze and Brass Casting for Sleeve/Flange Bushings with ZCuSn6Zn6Pb3 Mechanical Processing
Let’s define your requirement
Send a product link, drawing or short brief. We’ll work through the details with you.
- Confirm the specificationGrade or model, size and intended use.
- Define your orderQuantity, finish or configuration, and samples.
- Agree the quotation scopeIncluded work, key checks and delivery needs.
-
Component FormFlange
-
Applicable IndustriesEnergy & MiningMaterialZCuSn6Zn6Pb3
-
TypeSleeve
-
Inside Diameter Tolerance±0.05 mmLubricationOil
-
Outside Diameter Tolerance±0.05 mmOverall Length103 mm(4.06in)
-
brandReliamaterialZCuSn6Zn6Pb3
-
Casting methodCentrifugal casting
-
density8.9Brinell hardness590-685
-
Fusing point905
Bronze and brass casting with mechanical processing is offered for sleeve and flange bushing projects. The sleeve uses ZCuSn6Zn6Pb3 material, centrifugal casting and oil lubrication, with energy and mining as application directions. Its overall length is 103 mm (4.06 in), providing a specific dimensional reference for the bushing inquiry.
Inside and outside fits
The inside-diameter and outside-diameter tolerances are ±0.05 mm each. Consider the two fits separately when defining the sleeve for its mating assembly, because the bore and external surface relate to different dimensions. Identify the required nominal diameters on the component drawing and connect each tolerance to the relevant measurement, keeping the overall length in the same dimensional review.
Oil lubrication in the intended service
Oil is the lubrication choice for this sleeve, so the lubrication arrangement belongs in the application discussion. For an energy or mining component, explain the intended operating conditions and how oil will reach the relevant surfaces. This connects the stated lubrication type to the actual assembly without assuming a particular oil grade, maintenance interval or operating load.
Sleeve form and flange-bushing requests
A sleeve inquiry can begin with the bore, outside diameter and length, while a flange-bushing request should also define the flange geometry required by the design. Casting and mechanical processing can then be discussed against that specific form. The ZCuSn6Zn6Pb3 designation should remain attached to the material requirement throughout the inquiry, including any dimensional acceptance agreed for the processed component.
The Brinell hardness range is 590–685. Include the applicable material acceptance and hardness measurement requirements when reviewing the bushing, so that dimensional fit and material criteria are considered together. This keeps the centrifugal-cast sleeve discussion specific to its drawing and intended lubricated service.
